|
1956
Vespa VL3T
Body Work
|
|
Vespa VL3T Wiring
This section will focus on images and descriptions of the work done on
my VL3T to run the wiring.
A new harness is being put in to the scooter. I am also adding a
VAPE electronic ignition and removing the battery. We will see
how the original Vespa VL3T switches need to be modified to accomodate
the new wiring.
Here are some photos of the original stator which is being replaced.
I ran the new harness. Not 100% how this will
all hook up but I will show photos when that happens. Here is the
back end on the left. On the right is the front end of the
harness. On the front end right are the wires that will lead to
the switch and to the left are the wires that run from the switch to
the headlight.
 
One problem is the limited space to get the wires from the switch,
through the fork and back out to the headlight. I modified this a
bit to wrap the wires in triple insulation to prevent any damage from
the rotating fork. It is not easy to see but down in there are
the wires wrapped in 3 layers of shrink wrap.
|
|
|
